3.5. 'Pressure Products' Tab Pane

Figure 3.5. 'Pressure Products' Tab Pane

This tab pane consists of the following components:

'Barometric Pressure': If this checkbox is selected, the output product will contain a band with the barometric pressure derived for each pixel.
'Use GETASSE30 DEM for Barometric Pressure Computation': If this checkbox is selected, the barometric pressure will be computed using the GETASSE30 DEM instead of the tie point DEM. Note that this option can only be used if the GETASSE30 DEM has been installed in BEAM.
'Surface Pressure (FUB, O2 Project)': If this checkbox is selected, the output product will contain a band with the surface pressure, derived as described in Section 2.2.1 for each pixel.
'Apply Tropical Atmosphere (instead of USS standard) in FUB algorithm': If this checkbox is selected, a tropical atmosphere (instead of USS standard) is used within the FUB surface pressure algorithm.
''P1' (LISE, O2 project, all surfaces)': If this checkbox is selected, the output product will contain a band with the 'P1' pressure, derived as described in Section 2.2.2 for each pixel over each surface.
'Surface pressure (LISE, O2 project, land)': If this checkbox is selected, the output product will contain a band with the surface pressure, derived as described in Section 2.2.3 for each pixel over land.
''P2' (LISE, O2 project, ocean)': If this checkbox is selected, the output product will contain a band with the 'P2' pressure, derived as described in Section 2.2.3 for each pixel over ocean.
''PScatt' (LISE, O2 project, ocean)': If this checkbox is selected, the output product will contain a band with the 'PScatt' pressure, derived as described in Section 2.2.5 for each pixel over ocean.